Aruba S3500 Series Wired Access Point
| Installation Guide
Installation |
31
Installing and Removing a Fan Tray
The fan tray is field-replaceable and hot-swappable. Hot-swapping allows you to replace the fan tray
without having to power down the S3500.
1. Remove the old fan tray.
a. Using a Phillips Head screwdriver, turn the hinged captive screws counter-clockwise until loose
(they cannot be removed completely).
b. Firmly grasp both of the hinged captive screws and pull the spring loaded hinge down until you are
sure the hinges are disengaged. Use the fan tray handle to pull the fan out.
2. Align the new fan tray module with opening in the mobility access switch, as shown in
Figure 19
.
3. Pull down the hinged captive screws on the new fan tray module and align its tabs with the slots on
either side of the opening.
4. Slide the fan tray module into the mobility access switch.
5. Lift both the hinged captive screws into the lock position then secure the fan tray module by tightening
the captive screws.
Figure 19
Installing a Fan Tray
Use standard ESD precautions when installing or removing a fan tray module.
Ensure that fan tray module is correctly aligned with the opening on the S3500. Failure to do so can result in
damage to the fan tray module.
