8
Before Use
■
When setting up the device
Please be careful about the following when setting up the
device.
●
Please ask qualified person for
Installation work.
●
When setting up, leave at least
100 mm (3.9
) of space at the top,
left, right and back. Also, do not block
the space between the monitor and
the floor. When other attachments
are used, follow the set up manuals
for the corresponding attachments. (If
dimensions are not stated in the set
up manual, then leave at least
100 mm (3.9
) of space at the top/
bottom, left/right and back.)
●
Do not place monitor face down, on
its side or upside down.
●
Before connecting devices, please turn
the power OFF.
Make connections following the manual of each device.
●
Avoid set up in locations subjected to
vibration or shock.
Subjecting the monitor to vibration and shock damages
internal components and is the cause of malfunctions.
Please set up in a location not subjected to vibration or
shock.
●
Don’t give a shock to the monitor and
AC adaptor by falling etc.
It may cause fire or electrical shock.
Disconnect AC cord from power outlet and contact
dealer.
●
Use a socket in a position where the
AC cord plug can be easily reached.
●
Do not set up in places near high
voltage lines, near power sources, or
strong magnetism.
Setting up the monitor near high voltage lines or power
sources may subject it to interference.
●
Avoid direct sunlight, set up away
from thermal equipment. Also, do not
use outdoors.
It may cause deformation or damage to the cabinet.
●
The terminal parts of the SDI terminal
and DVI-D terminal are vulnerable to
static electricity, so be sure to work
with care at installation.
When working with the monitor, be sure to observe the
following.
●
Do not touch the connector pins.
●
Do not touch pins at the end of any cable connected
to a connector.
●
Take anti-static precautions such as using an
anti-static wrist strap when working.
The warning label is displayed as shown
in the right-hand diagram in proximity
to the SDI terminal and DVI-D terminal.
DVI-D and SDI connectors are sensitive
to electrostatic discharge (ESD). It is
recommended to maintain humidity levels in the room,
provide conductive flooring in order to prevent damage
due to ESD. Operators shall be trained in basics of
electrostatic charge, its effects on electronic
components and explanation on prevention methods
such as usage of wrist straps and discharge one’s body
to ground before touching the connectors.
●
Do not use damaged cables.
●
Intended for use according to EMC
information
The monitor is intended for use in the electromagnetic
environments designated in “EMC Relevant
Information” on page 36.
●
Do not grasp the liquid crystal panel.
Do not grasp or exert strong pressure on the liquid
crystal panel. Use special caution when transporting.
●
For transportation or setting, please
contact the dealer.
■
When setting up the AC adaptor
Please be careful about the following when setting up the
AC adaptor.
●
The AC adaptor must be installed in a
level position in a dry and stable
location.
Failure to do so may result in the instrument falling,
causing operator injury and damage to the instrument.
●
Do not install the AC adaptor in a
vertical position.
Fluid or dust may get inside this instrument resulting in
fire or electric shock.
EJ-MLA26_EN_Arthrex.book Page 8 Wednesday, August 8, 2012 11:58 AM
