GB
10
9
1
Runners (x2)
2
Shelf - 12 recesses
3
Dowels (x2)
1
2
3
Loading and layout advice
Each shelf can be used as a storage shelf, sliding shelf or display shelf. The shelves in your cabinet have 12
recesses, allowing your bottles to be stored safely.
Shelf specially developed for wine cabinets in the Oxygen range.
14 dowel pins supplied in the accessories bag.
Installing a shelf in storage version:
To install bottles on a storage shelf, proceed as follows:
1.
Insert 2 runners in the shelf support strips. For each
shelf, position one runner on the right and one runner on the
left (see diagram 1). Ensure that the runners are correctly
fixed in their housing (see diagram 2)
2.
Place the shelf in the 2 runners. (see diagram 3)
3.
Place a locking dowel in each of the 2 holes
located at the front of the shelf, in the upper section.
These pins then fix the shelf with respect to the runner and
prevent any unwanted movement.
4.
Start by placing bottles in each recess of the back
row with the base of the bottle towards the back.
5.
Continue by placing the bottles in the opposite
direction on the front row.
6.
Continue stacking the bottles, ensuring that no
bottles touch the back wall.
7.
A storage shelf can support a maximum of 6
rows of 12 bottles, i.e.72 traditional Bordeaux bottles
(97 kg).
Diagram 1
Diagram 3
Diagram 2
N.B:
For optimal use of your storage shelf, attach the rubber studs to the rear of the shelf, one on the
left, the other on the right, ensuring that no bottles touch the back wall.
9
Turn the door through 180°.
Warning: the door is very heavy.
Take any necessary precautions
to ensure that you do not injure
yourself or drop it.
10
Put the door back on its pin.
12
11
13
11
Put in place the upper hinge.
12
Screw the hinge so that the door is
completely parallel to the cabinet.
Check that the door seal adheres well
to the cabinet (by closing the door),
to ensure that it is completely air-tight.
13
Put in place the caps.
7
Unscrew the two screws and the door
catch.
Unscrew the two screws on the
opposite side and remove the two
washers.
7
8
8
Mount the door catch on the desired
opening side, using screws.
Replace
the washers, then the screws,
on the side opposite the door catch.
