6
DLC300 Function Module Installation and Operations Manual
DLC300 Function Module
Table 1.
DLC300 Elements
Item
DLC300 Element
for details, see...
2
Two SFP sockets and status LEDs (ACT and STAT) for the
following primary and secondary optical connections:
•
TX—Transmit
•
RX—Receive
Cabling the DLC300 Module (page 14)
and
Understanding the Rear Panel Status LEDs
(page 20)
3
Rear panel alarm indicator LED (OK).
Understanding the Rear Panel Status LEDs
(page 20)
4
Configuration DIP switches:
•
SW1—Video rate lockout
•
SW2—Input signal source and standby signal format
•
SW3—Video processing, alarm and optical reversion
control
Setting the Configuration DIP Switches
(page 9)
5
Mode select switch SW4. Determines operating mode;
transmit, receive, or repeat.
Setting the SW4 Mode Select Switch (page
9)
6
Front panel module and TX/RX status LEDs:
•
OK—Alarm indicator
•
EMS—Element Management System indicator
•
TX—Transmit signal indicators; one for the primary
(PRI) and one for the secondary (SEC) SFP
•
RX—Receive signal indicators; one for the primary (PRI)
and one for the secondary (SEC) SFP
Understanding the Front Panel Status LEDs
(page 16)
7
Front panel signal rate LEDs:
•
3G—3G-SDI signal indicator (2.97
Gb/s
and
2.97/1.001
Gb/s
)
•
HD—High definition signal indicator (1.485
Gb/s
and
1.485/1.001
Gb/s)
•
SD—SD-SDI signal indicator
•
ASI—DVB-ASI signal indicator
•
ATSC—ATSC signal indicator
Understanding the Front Panel Status LEDs
(page 16)
8
Front panel monitor mini 75 Ohm SMB output jack.
Using the Monitor Jack (page 19)
9
Backplane connector—Provides power to the module,
allows the module to share signals with other function
modules, and is used for alarm and management signals.
N/A
(Continued)
