Page 10 ·
586
TECPak
User’s Manual
Settings
All parameters of the
TECPak
can be viewed and changed over the computer
interface.
Most parameters can be changed using a standard command, as defined in the
Computer Interfacing Manual
or through the
Settings…
dialog within
Arroyo
Control
. Below is a list of the most common settings and the corresponding
computer command to change it.
Name
Description
Factory
Default
Computer
Command
Basic Settings
Mode
This set the operating mode (
T
Mode
,
R Mode
, or
Ite Mode
) of
the temperature controller.
T Mode
TEC:MODE
Mount
Specify the mount connected to
the
TECPak
. If using a
LaserMount
, select the
appropriate model. Otherwise,
select
User Defined
.
User
Defined
TEC:MOUNT
I Lim
I Lim
sets the current limit of
the temperature controller. The
limit should be set to a value
that is suitable for your Peltier
device.
3A
TEC:LIM:ITE
Gain
Gain
controls the response of
the temperature controller.
Select
PID
for direct access to
the PID parameters. Read more
on setting gain below.
30
TEC:GAIN
PID P
The proportional term of the
PID loop. Will only be available
if
Gain
is set to
PID
.
1
TEC:PID
PID I
The integral term of the PID
loop. Will only be available if
Gain
is set to
PID
.
0.01
TEC:PID
PID D
The derivative term of the PID
loop. Will only be available if
Gain
is set to
PID
.
0
TEC:PID
