Q-POWER 107 SERIES HYDRAULIC SQUEEZE CRUSH
ASSEMBLY
Your crush will come fully assembled with the options you have ordered already fitted to the crush.
However, it will be necessary to connect the hydraulic crush to a power source. The following guide
will assist you in properly setting up your crush for use.
A certified electrician is required to connect the Electric Power Pack to your unit. For full details
on installation, refer to the Power Pack manual by scanning the QR Code on your phone below.
Q-POWER 107 SERIES
Q-POWER 104 SERIES
OPERATING THE Q-POWER CATTLE CRUSH
1. Ensure the yoke gate, rear gate, and all access points are closed before the animal enters
the crush.
2. Open rear gate for the animal to enter the cattle crush enclosure.
3. Close rear gate.
4. Open yoke gate slightly more than the neck size of the animal to tempt the animal to stick its
head through the yoke gate. When neck of animal is in the correct position, quickly close the
yoke gate securely on the animal’s neck.
5. If required, side squeeze animal and engage head restraint to restrain further movement.
6. If the animal applies excessive pulling pressure on yoke gate, it is recommended to use the
anti-backing bar behind cattle rump.
27 | Q-POWER 107 SERIES HYDRAULIC SQUEEZE CRUSH ASSEMBLY
DO NOT ATTEMPT TO CONNECT THE ELECTRIC POWER
PACKS IF YOU ARE NOT A CERTIFIED ELECTRICIAN.
ENSURE ALL CRUSH FUNCTIONS AND ADD-ONS ARE
WORKING PROPERLY BEFORE OPERATING.
CONFIRM ANIMAL IS SECURELY HELD BEFORE CARRYING
OUT ANY HUSBANDRY WORK.
