Wood dowel
x8
Assembly Instructions
Norma Jean Sewing Machine Cabinet
Page 17
Step 24.
Thread DrawerConnecting Bolts (8 total)
into pre-drilled holes in Top Drawers Front (Px4).
Install DrawerCams (8 total) in Drawer side
(Sx4, Tx4) by pushing a Cam into each hole flush
with surface (as shown in FIG. 22).
Step 26.
Attach the Metal handle to the Top Drawers
Front (P) using 8/32x3/4” Bolt (x4) (as shown in FIG.
25).
NOTE:
The Metal pull is a 3 piece pull- 2 Rosettes and
Handle. Attach the two Rosettes loosely on front,
insert Handle into end holes and tighten bolts.
Step 25.
Attach Top Drawer Sides (S,T) to Top
Drawer Front (P), guide Drawer Connecting Bolts
into holes in Drawer Sides (S,T), turn DrawerCams
to locked position.
Slide Drawer Bottom (Q) along grooves on the
Sides Into the Groove In Drawer Front (P) (as
shown in FIG. 23).
On the other side, attach the Drawer Back (R) to
Drawer sides (S,T) with the #10x1-1/2” Flathead
Screw (x16) (as shown in FIG. 24).
FIG. 22
The Drawer may now be installed into your cabinet as
shown. The middle slot of the drawer side, slides onto
the drawer runner. Do not place the drawers on top of
the drawer runners.
Drawer Connecting
Bolts
x8
Drawer
Cams
x8
FIG. 23
FIG. 25.
FIG. 24
#10x1-1/2”
Flathead Screw
x16
Metal Handle
x4
#8/32x3/4”
Handle Bolts
x8
Q
P
T
T
S
S
R
R
180°
P
T
S
