ARRI L5, User Manual, Page: 8 / 52

Safety Infor
m
ation
8
Specific Safety Information
Intensive use can cause the surface and the heat sink
to become hot. Let the product cool down complete
before you handle it.
Never cover air vents and the heat sink during opera-
tion. Keep a minimum clearance around the product
of 0.5 m (1.65 ft).
WARNING: Intense light. The product is equipped
with high intensity LEDs which emit at high luminance
levels. Never look direct into the light source.
Never point a light beam from another luminaire into
the light source. Do not place the product on heat
sources. Intense heat cause automatic power off dur-
ing operation.
Devices and accessories must be secured against fall
when mounted above floor level. Always observe
common and local safety regulations.
Never use the cables for transportation. Never hang
the product on its cables. Do not hang a battery pack
on its connection cable to the product.
CAUTION: High voltage! Always disconnect the prod-
uct complete from mains voltage before you connect
or disconnect a cable or replace the fuse of the prod-
uct.
Always check that the local AC power matches the
voltage and frequency range printed on the type label
of the product before use. Never use the product
when the AC power does not match.
Always check that the supply voltage of the battery
pack matches the voltage range printed on the type
label of the product before use.
Never connect the product to a dimmer-system or a
dimmer-channel in non-dim mode. To do so will dam-
age the electronics. Damages caused by connecting
the product to a not suitable power source are not
covered by the warranty.
Never bypass any fuse.
Always keep cables away from the product during
operation. Do not tilt the power cable directly after the
connector. Water could immerse and cause short cir-
cuits and damage the connector.
Disconnect all cables prior to transport.