22
Step 14
10.3
Fine tuning of the current PID values
1
Set the Joystick
Ramp
to
ZERO
(Pan & Tilt) (K4 & K5)
2
Physical test to determine the necessary tilt power value.
Touch the lens at the front end, slowly push the camera
down and check if the tilt axis starts to slip.
3
If the
Tilt
axis
slips
, you
must
increase
the
Power value
for the
Tilt
axis.
NOTE
When the remote head starts to
vibrate
,
reduce
the
Power value
!
4
Once the
Tilt Power
value meets your
expectations, the same
Power
value will
be used for the
Pan
axis as well.
Press
Save!
5
Adjusting the
PID
values:
NOTE
Now a camera picture on a larger monitor
screen is needed.
6
Choose and frame a fixed point in the set.
7
Use the joystick and move the remote head
to the selected position in the set and stop
the head right there.
8
Check if the camera:
• stops at the selected point
• whether the camera exceeds the point
• whether the camera is bouncing left and right
9
If the camera exceeds the desired point,
increase
the
P
and
D values
in increments of five.
NOTE
The
D value
must be min.
5
higher
then the
P value.
NOTE
When the remote head starts to
vibrate
,
reduce
the
P value
!
10
If the remote head
bounces
to the left and right
when you reach the desired point, you must
slowly
increase
the
D value
of the
Pan
axis.
11
Once the
Pan
PID
values meets your expectations,
reduce the P and D values by 10 and use the little
lower values for the
Tilt
axis.
Press
Save!
PID / Fine Tuning
Summary of Contents for KK.0037273
Page 44: ...44 Declaration of Conformity ...
