20
11
Additional Controls Setup
• Deadband
• Sensitivity
• Ramp Mode
• Filter
• Ratio
Select
Main
Select
Position
Select the
Axis
11.1
Deadband
This value determines when the remote head
responds after the control device (joystick)
has been moved.
NOTE
If the
DRW-1
wheels or the
DEH-1
encoder head
is used as a controller,
Deadband
must be set
to
0
!
Otherwise there would be a
delay
in response!
11.2
Sensitivity
Submenu
All three parameters are related to each other.
If the speed is adjusted to a value below 50,
keep the ramp value as low as possible.
If the value is too high, there will be more or
less
no
movement in the end.
NOTE
If the
DRW-1
wheels or the
DEH-1
encoder head is used as a controller,
Sensitivity
must be set to
0!
Otherwise there would be a
delay
in response!
Additional Controls Setup
Start
50%
100%
Start
50%
100%
Joystick
value
(Speed)
max.
Joystick
range
Speed Value
100%
50%
0%
Deadband
Sensitivity
(minus Value)
Start Ramp
Stop Ramp