Installation and Operation
17
8
Installation and Operation
WARNING
Falling Camera Accessories
If the system is inadequately built up or assembled, it can fall down and cause serious in-
juries and damage to the system or property.
Installation and operation may only be carried out by trained personnel who are familiar with the
system. Observe accident prevention regulations.
Do not place the system on an unstable trolley or hand truck, stand, tripod, bracket, table or any
other unstable support device.
Always place the camera on dedicated support devices.
Secure the system and its accessories against falling and tipping over. Observe the general and
local safety regulations.
When using the system on camera cranes, a suitable safety rope must be used.
Use only accessories approved by ARRI. The use of accessories not approved by ARRI is at
your own risk. Please observe all relevant safety guidelines.
CAUTION
Improper installation of camera accessories
Crushing hazard for fingers and/or hands.
Before mounting ARRI accessories or recommended third-party accessories (such as lenses,
mechanical accessories, electronic accessories), read the operating instructions provided by the
manufacturer.
Always use the tools specified by the manufacturer for mounting.
CAUTION
Improper vertical adjustment of the camera stabilizer ring
Crushing hazard for fingers and/or hands after opening the clamping levers.
Before mounting the camera stabilizer ring, read the operating instructions provided by the
manufacturer.
The height of the stabilizer ring should always be adjusted by two people
Always use the tools specified by the manufacturer for mounting.
8.1
Mechanical Setup
Mounting the optional RMB-3 brackets
(K2.0006186) on top of both paddles, allows both
pedals to be held together via a ø19mm rod.
The RMB-3 brackets are attached to the Digital
Encoder Pedals DEP-1 by a clamping lever.
Turn the clamping lever clockwise until the clamp-
ing lever no longer moves under medium pres-
sure.
