Installation and Operation
20
8.6.2 Additional Controls Setup
Dead Band
Sensitivity
Filter
Ratio
Follow the steps above to achieve the control setup you want.
8.6.3 Dead Band
ATTENTION
If the Digital Encoder Pedals DEP-1 are used as a controller, Deadband shall be set to
0 - 3
.
Higher values can cause unwanted lag of response.
Selecting Deadband opens a new touchscreen slider that allows to change the Deadband values on the
selected axis.
Deadband sets the starting point of the control.
This value defines when the setpoint will react after the control was changed.
8.6.4 Sensitivity for Control Devices
ATTENTION
The sensitivity has to be set separately for each axis.
Redo the procedure for all axes and press
OK
.
Selecting Sensitivity will open a new Touchscreen slider that allows
you to change the sensitivity of the control device for the selected axis.
