ARMANNI CP LIGHT evo 030, Operator'S Manual

Page: 33 / 43

Instruction handbook - Maintenance
ARMANNI
5.2
Periodical maintenance checks and technical advice
Hydraulic system
Check the seal of all pipes, pipe fittings, gaskets and oleodynamic cylinder.
Check the oil level, with the forks completely lifted, by unscrewing and removing the cap
on the gearcase tank; with the help of a scaled rod check that the oil level is at about 3
cm from the bottom. If the oil level should not reach this value, carry out an oil topping
up with LI 32 oil to obtain the optimum value.
Chain, nut and screw tightening check
Check all truck screws and nuts and particularly wheels, traction motor and lifting group.
Check and adjust the lifting chain, pivots and chain fastening tie rods (check that the
hole of the chain fastening pivot has no backlash, otherwise replace the chain fastening
block by contacting the Technical Assistance). Replace periodically chain, pulley, pivots
and tie rod.
Forks adjustment
In case of lateral backlash of the forks operate on the four nylon sliding blocks inside the
mast (See Fig. 5.1) by means of a ch 5 setscrew wrench on the dowel inside the bush
supporting them; rotate clockwise to reduce the backlash and anticlockwise to increase
it. Always distribute equally the adjustment on all four sliding blocks. If the forks are
inclined downwards or onwards operate on the two eccentric pivots placed on the level of
the upper nylon sliding blocks; rotate the pivots one symmetrical to the other in
comparison with the machine middle axis in order to avoid to lift only one of the two
forks. NB - The keys for this adjustment can be supplied by ARMANNI.
Greasing
Grease the battery terminals with vaseline grease.
Grease the masts
Grease the chain and relative pulley
Electric parts
Check the insulation of the electric installation
Check the battery and the terminal oxidation (water level)
Check the tightening of the power cables in the anchor points
Check the wear of the lifting motor brushes; if necessary, replace them.
5-2