Arkbird
-20-
7
Balance Mode
1. First switch to "manual mode", set the rudder angle on the remote control to 100%, fine-tune
it back to center, and set the amount of forward and reverse rudder manually controlled on the
remote control.
2. Then switch to "Balance Mode", if the midpoint is correctly calibrated, the plane should be
placed horizontally, the rudder surface should be basically at the midpoint, otherwise please
recalibrate the midpoint. (Refer to OSD menu)
3. When tilting the aircraft on the roll and pitch axes, the flight control should give the correct
movement that allows the aircraft to return to level flight.
4. Tilt the aircraft in the roll direction, the fuselage tilts to the right, and a control quantity
for the aircraft to roll to the left should be automatically given on the aileron. If the fuselage
is tilted to the left, a control amount for the aircraft to roll to the right should be automatically
given on the aileron. As shown below:
If the given roll direction is opposite, please adjust the roll value from “Norm”to "Reverse"
in the menu "ROLL KEY1".
If other mixing controls are used, it is also to observe whether the flight control gives the
correct movement to restore the plane to level flight.
5. Elevator detection: tilt the aircraft in the pitch direction, the nose is tilted, and a control
amount to make the aircraft bow should be automatically given in the elevator. The fuselage lowers
its head, and a control quantity for raising the aircraft's head should be automatically given
on the lifting. As shown below:
If the pitch direction given is opposite, please dial switch 2 to the other direction.
If other mixing controls are used, it is also to observe whether the flight control gives the
correct movement to restore the plane to level flight.
Summary of Contents for 3.0
Page 22: ...Arkbird 22 ...
