Arkbird
-38-
13
FAQ and Solutions
：
★
When switching to Balance Mode, the elevator will lift up a bit because the “Elevate Angle in a level flight” in
the menu is defaulted as 5°. Which means the plane will rise a bit in a level flight to ensure a level route.
★
If the aileron move to the edge but you cannot enter the menu, please check if the route setup is too small
on the remote control.
★
For airplanes with too big servo angle installed, it may shake due to excessive stability. It is recommended to
change the servo angle installation position and reduce the control amount at this time. And set the aileron,
elevator and rudder amount of 100% normally on the remote control.
Reduce the installation rudder angle and set the rudder angle to 100% on the remote
controller
14
Other FAQ
：
Q
：
There is no OSD / OSD is
incomplete
A
：
Check the wiring, restart the power, check if the camera is turned on, to see if the VDLED flashes fast.
If there shows OSD but incomplete, check PAL/ NTSC signal custom option or change display device, some
USB-AV card output is incomplete
Q: The OSD cannot be superimposed, and the OSD disappears after plugging in the camera
A: Please unplug the camera and replace the P/N mode of the flight control or the P/N mode of
the display. If it still does not work, please replace the camera and choose the mainstream FPV
camera (some surveillance cameras cannot superimpose OSD).
Q
：
Cannot locate home, displaying “Waiting GPS Home”
A
：
Seeing OSD “Waiting GPS Home” proves GPS wiring is OK, otherwise, please check GPS wiring.
GPS’s white antenna shall face up; keep GPS away from Video TX and Camera. Some inferior Video TX’s
Summary of Contents for 3.0
Page 22: ...Arkbird 22 ...
