Arjohuntleigh RotoProne, User Manual

Page: 63 / 88

3-23
• Press
Done
button.
Scale
screen will appear.
If scale was not zeroed or if weight is not correct, push the
Adjust Weight
button on the
Scale
screen and enter the most accurate and current weight.
• Press Home button. The Home / Pull Lock Pin
screen will appear.
4. Adjust any therapy settings as needed (Therapy settings
can be adjusted at any time):
• Press
Therapy Settings button. The Therapy Settings Selection screen will appear.
• Select the Prone Settings or Supine Settings button, as needed.
• Adjust settings within the Prone and / or Supine Therapy Settings screens, as needed.
• Press Done button to return to the Therapy Settings Selection screen.
• Press Home button to return to the Home Screen.
5. Adjust patient surface height and Trendelenburg / Reverse Trendelenburg position as needed.
Trendelenburg angle is not available in the prone position.
starting Therapy
Kinetic Therapy begins in the supine position and will continue until directed to move to prone. To begin
therapy (in the supine position) follow all the steps listed below. Once patient placement is completed and
the patient is rotating in a supine position,
only then can the patient be moved into the prone position and
begin Prone Therapy.
Procedures for Prone Therapy are detailed in the section immediately following this
Starting Therapy
section.
1.
Ensure all patient placement procedures (pack installation, initial patient weighing, etc.) is complete.
These procedures are detailed in the previous sections of this chapter.