screws and then place the assembled Curb in
the position laid out on the shower curb corres-
ponding to the marks that you made. Make sure
to fill the corners where the screws were in-
serted and the ends with silicone so as to seal
any gaps that might leak but do this after the
wall jams are installed
(C)
.
2)
Place a Wall Jamb ZD-1006 (#3) against the
wall and down into the Curb. Use a level to po-
sition the jamb plumb, then mark the installa-
tion holes with a pen or pencil. Repeat this pro-
cedure for the other jamb
(D)
. Now drill the 6
holes with a 3/16” masonry bit (9/64” for fiber-
glass, & without anchors). Then insert the 6)-
ZV935 screw anchors (#15) in the holes. Fasten
the ZD-1006 wall jambs in place using the #8X1-
1/4 Phillips Pan Head screws provided (#14).
Fill the corner inside the ZSS-2101 to protect
against water leaks
(E)
.
3)
Place two Setting Blocks ZV902 (#13) into
the Curb on the side where your panel will be.
Insert the Glass into the ZSS-2101Curb and the
ZD-1006 Wall
Jamb.
Insert the 135 Post ZSS-
1105 (#19) into the Curb and onto the edge of
the glass
(F)
.
4)
Plumb your ZSS-1105 135° corner post.
Measure from the wall above the ZD-1006 Wall
Jamb over the glass to the outside and to the
center of the ZSS-1105 135° post. Add 1/8” to
the measurement then mark the header at that
dimension and cut. Repeat the procedure for
the other ZSS-2101 Header
(G)
.
Summary of Contents for CDFMP-135
Page 1: ......
