5)
Assemble the Header on the floor (like pre-
viously on the Curb) using the ZH135 135 de-
gree Header Bracket (#20) and the #8X1/4”
Header Curb Bracket Screws (#21). As the head-
ers are lying open end down, place the ZH135
Bracket onto the corner and align the miters,
corner bracket, and holes. Fasten the corner
together with the #8x1/4” screws (refer to
(C)
).
Now place the assembled header pieces over
and down onto the vertical posts. Attach the
Header to the Wall Jambs and 135° Post from
the inside using a 1/8” drill bit to drill through
the header and into the wall jambs and 135°
Post being
extremely careful
not to drill into
the glass. Secure with the #6X3/8” screws (#16)
(H)
. Insert the ZV909 Wedge Vinyl (#18) into
the jambs on both sides of the glass. A block of
wood will help push the vinyl in. Slightly wet the
vinyl with water to ease install. The flat side
goes against the glass. Notice the locking
groove
(I)
. Insert the ZV906 Horizontal Wedge
Vinyl into the header and curb (#17) in between
the metal and glass without stretching it, both
inside and out, top and bottom. Notice the lock-
ing groove
(J)
.
6)
Now you need to cut the Snap In Fillers ZSS-
1102 (#4). Measure from inside edge of the ZSS-
1105 to inside edge of the ZD-1006 (the daylight
door opening). Cut the fillers to these dimen-
sions. Snap the fillers
into the ZSS-2101’s top
and bottom. There is a small lip on the filler.
This faces to the outside of the unit
(K)
.
7)
Hang the door. Slide the ZD-8004 Magnetic
Latch Jamb (#11) over the wall jamb or corner
post, whichever side the door will latch on. In-
stall the door by sliding the ZD-2505A Door
Summary of Contents for CDFMP-135
Page 1: ......
