Perimeter Sensor (SN-5)
Mounting the SN-5
The Perimeter sensor uses high frequency microwave technology to detect mass density movement
around the motorcycle. The signal can transmit through the seat, fiberglass, leather and plastic, but
not metal. It is recommended to place this sensor under the seat as close as possible to the center
of the motorcycle. With the provided Velcro, you can mount this sensor on top of the battery or any
flat surface, making sure that the top side of the sensor is facing upwards. Place the perimeter
sensor as faraway from the MCM as possible.
Adjusting the Sensor
Although the sensor is pre set from the factory it may be necessary to adjust the sensitivity to suit your
needs. Remove the plastic cap and turn the adjustment screw.
To increase sensitivity, turn adjustment screw clockwise.
To decrease sensitivity, turn the adjustment screw counter clockwise.
Plastic Cap:
Remove to adjust
sensitivity
To Accessory Harness on Main
Control Module (MCM)
Note: Do not turn sensitivity above half way. Doing
so may cause false alarms.
19
8
Operating Instructions
The SR-i900, by default, will be in auto arm mode and will activate with the perimeter sensor off and
the siren on, five seconds after turning the ignition key off.
Auto Arm
Activate perimeter sensor
Panic / Stop Trigger
(when system is armed)
Auto Disarm
Manual Disarm
Manual Arm
(system has to be manually disarmed first)
Walk next to
bike. Turn ignition
key on
Siren:
Chirp 3 Times
Turn Signals:
Flash 1 Time
Siren:
Chirp 1 Time
Turn Signals:
Flash 1 Time
Turn ignition key
off. Walk away
from bike
Press and hold
button 1
Siren:
Chirp 3 Times
Turn Signals:
Flash 1 Time
Siren:
Chirp 1 Time
Turn Signals:
Flash 1 Time
Press and hold
button 2
Note: If the system is manually disarmed it will stay
in disarmed mode. At this mode the system
will not auto arm upon turning ignition key off.
Siren:
Chirp 4 Times
Turn Signals:
Flash 1 Time
Press and hold
button 1 and 2
Siren:
Chirp 6 Times
Turn Signals:
Flash 1 Time
Press and hold
button 1
Summary of Contents for Scorpio
Page 5: ...4 Installation Diagram ...
