a1
Problem Possible
Cause
Solution
Will not arm
RFID antenna not connected
Verify connection from MCM to RFID
antenna
Power or ground not connected
Verify connection to power lead and
ground connection
Orange wire not connected
Verify connection to 12 volt wire with
key on. (tail light on most bikes)
Turn signals will not
flash
Grey wires from GEN-1 not
connected or connected to wrong
wires
Test wires and change connections
to correct wires
Perimeter Sensor not
working
Sensor not connected
Check connections
System set on default with sensor
off
Enter Programming mode and
change default
Ignition Disable does
not work
Orange wire from GEN-1 not
connected
Connect orange wire from GEN-1 to
12 volt (+) with ignition key on. In
most bikes that is the tail light wire
Ignition disable not connected to
correct wire on bike
Refer to options on the ignition
disable instruction page. Test
selected wire before reconnecting
RID-5 wires.
Troubleshooting guide
2
Manual Override Procedure
Programming Personal
Override Code
14
Enter Programming Mode
14
Select number of flashes for Code 14
Using Code in case of lost remote 14
Transceiver Information
Alarm Triggers
15
Range Confirmation Signal
16
Checking Violation Display
16
Transceiver Battery Information
17
Low Battery Stages
17
Optional Accessory Instructions
Perimeter Sensor (SN 5)
19
Back up Battery
20
Ignition Disable / Anti hijack Unit 21-22
Appendix
Trouble Shooting guide
a1
Limited Warranty
a2
Important Information / Notes
a3
FCC Information
a3
Special Note
a3
Summary of Contents for Scorpio
Page 5: ...4 Installation Diagram ...
