Aritronix Scorpio, User Manual

Page: 7 / 14

21
Ignition Disable / Anti-hijack Module (RID-5)
Installation
1.
Cut the Ignition / Engine control wire (refer to options on page 22)
2. Attempt to start bike to test if correct wire is selected. If bike starts the wrong wire is selected.
(contact Aritronix for assistance) If bike does not start, correct wire was selected continue to
step 3.
3. When packaged the RID-5 wire ends have been treated with clear silicon to protect the ends
from fraying. Make sure they are stripped bare of this before continuing.
4. Connect one end of the cut wire to one of the blue tabbed wires in RID-5 with provided butt
connector or any other solid connection option.
5. Connect second end of the cut wire to second blue tabbed wire in RID-5 with provided butt
connector or any other solid connection option.
6. Test connections to insure that they are as solid as possible. *
7. Plug the RID-5 connector into the matching connector on the Accessory Harness.
8. Test RID-5 by activating alarm (without perimeter sensor) and try to start bike. If bike starts,
please contact Aritronix for assistance.
* Failure to test for a loose wire could cause an accidental engine cut off.
6
Color Codes:
(Color codes are not always valid. Always verify before making connections)
Ground (-) Tail Light Left Turn Signal Right Turn Signal
Honda Green Brown Orange Blue
Kawasaki Black Red Green Grey
Suzuki Black/White Brown Green or Black Grey
Yamaha Black Blue Green Brown
Harley Davidson Black Blue Brown Purple
Ducati Black Yellow White/Black White/Green
Using the T-tap Connectors and GEN-1 Connector
1) Place the female T-tap connector over wire, close and squeeze until it snaps.
2) Slip male T-tap connector over hinged end of the female connector to make a connection.
Motorcycle Wire
Female T-tap
1)
Motorcycle Wire
Wire from (GEN-1)
Female T-tap
Male T-Tap (GEN-1)
--------------------- Skip this page if using Factory Connector Kit --------------------
2)