10
7. Remove bolt from carriage frame. Install tension
spring from idler arm to carriage frame (Figure
10).
8. Attach front end of lift tube to the pivot rod link
with a clevis pin and hair pin (Figure 11). Attach
clevis rod to lift tube, being sure 2.00” to 3.00” of
thread is exposed between lift tube and clevis
assembly.
9. Attach rear end of lift tube to the actuator lever
with clevis pin and hair pin (Figure 11).
10. Slide lift lever onto pivot rod in the carriage frame.
Secure with groove pins.
NOTE:
Proceed to Installation in
Operation
section.
INSTALLATION
Before installing Sno-Thro remove all other
attachments according to their Owner/Operator
Manuals.
Install Rear Brackets
1. Attach rear hanger brackets to tractor frame with
two (2) 3/8-16 x 1" bolts provided (Figure 12).
IMPORTANT:
Install rear hanger brackets in front of
mower hanger brackets.
NOTE:
Rear hanger brackets should be spaced apart
15.56” (outside to outside). Use a rubber hammer to
achieve spacing if necessary.
Figure 11
1. Lift Tube
2. Pivot Rod (Link)
3. Clevis Pins
4. Hair Pins
5. Lift Lever
6. Clevis Rod
7. Actuator Lever
8. Groove Pins
9. Positive Lock Pins
10. Pivot Frame
11. Carriage Frame
12. Rear Pivot Rod
OTt2080
1
2
3
3
4
4
5
6
7
8
9
10
11
12
9
11
OPERATION
WARNING:
AVOID INJURY. Read and
understand
Assembly
and
Operational Safety
Rules
in
Safety
section before operating unit.
Figure 12
OTt0900
1. Mower Hanger
Bracket
2. Rear Hanger
Bracket
3. 3/8-16 x 1" Bolt
4. Nut
1
2
3
4
