Argo-Hytos EL7-E, Instruction Manual

Page: 10 / 60

EL7-E_Pokyny_Instructions_Hinweise_19152_1en_de_cz_04/2021
Page 10
www.argo-hytos.com
7.4.2 Program configuration
The EL7_mobile program is used to modify the operating parameters of digital electronics.
Basic features are:
-
minimum system requirements – Android from version 7, Apple from iOS 10.3.3.
- enables you to clearly set the parameters of electronics from a mobile device or tablet, without the need to connect via cables
- enables monitoring of basic parameters and signal measurement
- enables the performance of electronics firmware updates
- enables manual control of the connected valve or directional control valve
- enables you to send the log file of the electronics to the manufacturer for diagnostics
Installing and running the application:
- download the application either by searching for the term “EL7_mobile“ on the relevant applcation store or by using the QR code,
see below for the relevant platforms.
- after downloading the application and starting the installation, follow the instructions on the screen.
Warning!
The application must have Bluetooth and Location enabled.
The application will ask upon installation and Bluetooth and Location must be enabled.
At the same time the Location function on the mobile must be enabled and switched on.
With Bluetooth and Location Sharing enabled, the application will start scanning the area and display a list of units in range. There is no need to
pair or set anything, if the blue LED flashes, the blutooth module is active and the unit is displayed in the application. If the unit does not appear
and is actually within range, check again to see if location sharing really is enabled on the device.
If Bluetooth is not enabled,
the application will prompt
activation
List of units found in the
area to which log-in is
possible
The information panel with
basic information is displayed
by dragging from the left edge