ARGARD M10, Manual

Page: 20 / 28

Problem: The ARGARD M10 will not turn on.
Cause: This may be due to a malfunction in the battery, in case the headset
is dropped, or has sustained a sharp impact.
Solution: Reactivate the headset by charging the battery and pressing the TALK button.
The red TALK button light will be turned on (if the battery is full, the red light may not
be turned on). Continue pressing for approximately 5 seconds and then release.
Problem: The ARGARD M10 is connected, but it doesn’t work.
Cause: This may be due to a failed connection between the phone and
the ARGARD M10.
Solution: Reset the phone by turning it off and then on again. Then turn
the ARGARD M10 off and on again to create a new connection.
Problem: There are problems when trying to use the following functions: rejecting
a call, putting a call on hold, redialing, three-way calling, or voice dialing.
Cause: These functions are dependent a mobile phone that supports the activation
of a headset or hands-free unit.
Solution: Check these functions in the mobile phone's User Guide.
Problem: Ring tone for incoming call cannot be heard.
Cause: This may occur if the phone is set to silent mode or if the ring tone
is disabled.
Solution: Change the phone settings to enable the incoming call ring tone.
Troubleshooting & FAQ