Page 8
INITIAL CHANNEL SETUP AND OPERATION
1. Turn on the master power switch located on the right side of the LCD screen toward
the bottom of the screen.
2. Set the signal source and scan the channels available on your system by following
the instructions below:
Press Menu button on the lower right side of the PVS to enter the setup menu.
Press
Volume UP
or
Volume DOWN
button on the wired remote control to access
the Channel Setup menu
(the channel setup menu is denoted with the GLOBE icon
as highlighted above).
To navigate through the menu options, press
Channel UP
or
Channel DOWN
button
to highlight a setting. Press
Volume UP
or
Volume DOWN
button to adjust the
setting or open a setting menu. If another menu opens, press
Volume UP
or
Volume
DOWN
button to adjust the setting. Press the menu button on the side of the PVS to
exit the menu screen altogether.
First select the signal source: Select Air or Cable
Next, perform the Auto Scan. If you DO NOT perform this step, the PVS will not
recognize the channels you have available; it will only show the ARG logo on the
display.
Go down to the Auto Scan tab, select yes and
ENTER
.
The TV will now scan all of the channels available in the area. This may take a few
minutes, especially for digital channels. A bar display will indicate progress. Please be
patient as stopping the scan process will result in a reduced number of channels
available for viewing. When finished, the TV will tune to the lowest receivable channel.
It is now ready to use.
