Page 7
Figure 4
Figure 3 1
Pull the cable ties tightly around the bar so that the controller does not rotate
(figure1
).
Cut the ends of the ties to eliminate excess
(figure2
).
(Note: A typical treadmill installation
is shown below for reference in this manual. Equipment may differ from the one shown here
and placement of the remote control unit will vary.)
Connect one end of the coiled CAT-5 cable to the RJ-45 terminal located on the
underside of the remote control unit
(figures 3 and 4
)
The other end should be plugged
into the terminal marked
RJ45
on the PVS.
4. Plug the power supply into the terminal on the back of the PVS marked,
DC +12V.
Then connect the plug to a standard A/C 110V power outlet. This must be the
FINAL step to ensure the TV recognizes and properly initializes the wired remote
control unit or any accessories connected to the PVS. Figures 5 and 6 display how
the controller should look when completed.
Figure 1
Figure 3
Figure 2
Figure 5
Figure 6
