arf SLICK540 120E, Instruction Manual, Page: 42 / 46

Recommended control surface deflections:
Low Rate High Rate
Elevator 15 degrees 45-50 degrees
Rudder 25 degrees 40-45 degrees
Ailerons 25 degrees 35-40 degrees
FINAL ASSEMBLY AND PRE-FLIGHT INSPECTIONS
1. Before arriving at your flying field, be sure all your batteries are properly charged and all radio systems
are in proper working order.
2. Install the wings onto the fuselage being careful to align the wing tube with the wings and not force it.
The wing tube may be initially tight but will loosen some with use. Guide your servo wires into the
fuselage openings and connect to the proper aileron channels. Servo clips are recommended. Once you
have the wings fully seated in the fuselage tighten the wing bolts inside the fuselage.
3. Side force generators Assembly.
Cut the wing film needed to be install the SFG. Fixed the SFG Use M3X20 cap head bolts and washers
and balsa sheet.