APPENDIX
52
/w Commands
This /w command uses to write a flash image data into SAS host
adapter’s flash ROM from the file. You must restart the computer
for new BIOS to take effect after you complete the /w command.
The command syntax for the write command is as follows:
oflash/w filename – write, write binary into flash from filename
The following example shows a typical system response after
you completed the BIOS updated for the host adapter 1 from the
i13_1330.bin file:
C:\> oflash c/1 /w i13_1330.bin
-
C:\>
oflash
/c 1 /w i13_1330.bin
======================================
= Copyright (c) 2009 Areca, Inc. All rights reserved. =
= Areca SAS Host Adapter Flash Utility, Version: 1.00 =
======================================
Controller Information
Controller#01
DeviceID/Bus/DevFunc: 1330/4/0 I/O Address: CF00
Current : Adapter #00 [AT25F2048]
Writing 55808 bytes into flash 100%
Write flash OK
c:\>_
-
C:\>
oflash
/c 1 /r 1330bak.bin
======================================
= Copyright (c) 2009 Areca, Inc. All rights reserved. =
= Areca SAS Host Adapter Flash Utility, Version: 1.00 =
======================================
Controller Information
Controller#01
DeviceID/Bus/DevFunc: 1330/1/0 I/O Address: CF00
Current : Adapter #00 [AT25F2048]
Writing 262144 bytes into file 1330bak.bin: 100%
Read flash OK
c:\>_
Summary of Contents for ARC-1330 Series
Page 5: ......
