HARDWARE INSTALLATION
21
Figure 2-12, Global Indicator Connector
LED
Normal Status
Problem Indication
Fault LED
1. When the fault LED is lit,
there is no disk present.
2. When the fault LED is not
lit, then disk is present
and status is normal.
1. When the fault LED is blinking
(2 times/sec), that disk drive
has failed and should be hot
swapped immediately.
2. When the activity LED is lit and
fault LED is fast blinking (10
times/sec) there is rebuilding
activity on that disk drive.
Activity LED 1. When the activity LED is lit,
there is I/O activity on that
disk drive.
2. When the LED is not lit;
there is no activity on that
disk drive.
N/A
The following table is the fault/activity LED signal behavior.
The following diagrams shows global fault/activity connectors and
pin locations.
Step 6. Power up the System
Thoroughly check the installation, reinstall the computer cover, and
reconnect the power cord cables. Turn on the power switch at the
rear of the computer (if equipped) and then press the power button
at the front of the host computer.
Summary of Contents for ARC-1330 Series
Page 5: ......
