Owner’s Manual / Manuel de l’utilisateur
149cc FRONT TINE ROTOTILLER / 149 cm
3
ROTOCULTEUR DENT AVANT
38248 (5140-006)
12
For additional information visit online at
www.ardisam.com
or call 800-345-6007 M-F 8-5 CST
Fill Engine Crankcase
1. Add oil according to engine manual. Do not overfill. Use a
clean, high quality detergent oil. Use no special additives
with recommended oils. Do not mix oil with gasoline. Oil
level must be full. Check the oil level by checking the
engine’s oil dipstick if provided, or by removing oil fill plug.
Oil level should be up to the bottom of the fill plug opening.
2. Always check oil level before starting engine. Refer to
engine manual for capacity and type of oil to use.
CONTROL AND OPERATING SYMBOLS
FIGURE 10
shows common control and operating symbols that
may be found on the unit or in this manual. Before you operate
your unit, learn and understand the purpose for each symbol.
Choke
On/Off
Fuel Shutoff
CONTROLS
Drive Safety Control Lever
Pulling down on the drive safety control lever engages the tines.
Releasing the drive safety control lever disengages the tines to a
neutral position.
Belt Tension Adjustment
Proper belt tension is critical for good performance. After 30
minutes of operation, all cables may have to be adjusted due to
initial stretch. Thereafter, check tension after every two hours of
operation.
FIGURE 10
1. To increase belt tension, loosen upper jam nut in 1/8"
increments while holding lower jam nut in place.
SEE FIGURE 11
2. Check adjustment and instructions under “Check Belt
Tension” section.
This procedure can be repeated until conduit adjustment
bolts have no more adjustment left. If no more adjustment
can be made, belt may have to be replaced.
Depth Regulator Drag Stake
To Adjust Tilling Depth:
1. Remove lock pin.
2. Raise or lower the depth regulator. The lower the depth
regulator, the deeper the tilling depth.
3. Align hole in depth regulator lever with hole in depth
regulator bracket and replace lock pin.
SEE FIGURE 9
(page 11)
WARNING
THIS INFORMATION IS PROVIDED HERE ONLY TO
INTRODUCE THE CONTROLS. DO NOT START THE ENGINE
AT THIS TIME. STARTING AND OPERATING INSTRUCTIONS
ARE GIVEN IN THIS MANUAL. PLEASE READ THIS SECTION
AND ALL OPERATING AND SAFETY INSTRUCTIONS BEFORE
STARTING YOUR TILLER.
• AS A SAFETY PRECAUTION, THE DRIVE SAFETY
CONTROL LEVER WILL NOT LOCK IN THE FORWARD
POSITION.
• TO STOP THE TINES AT ANY TIME, RELEASE THE DRIVE
SAFETY CONTROL LEVER.
• ENGINE SHOULD BE OFF BEFORE ADJUSTING ANY
CONTROLS.
• DO NOT ADJUST TILLING DEPTH UNLESS DRIVE SAFETY
CONTROL LEVER IS RELEASED TO THE NEUTRAL
POSITION.
UPPER
JAM
NUT
LOWER
JAM
NUT
FIGURE 11
FIGURE 11
WARNING
THE RIGHT AND LEFT SIDES
OF YOUR ROTOTILLER ARE
DETERMINED FROM THE
OPERATING POSITION AS
YOU FACE THE DIRECTION
OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU
MUST ADD ENGINE OIL BEFORE STARTING ENGINE.
L
R
