ARDETEM PECA 30, Configuration Manual

Page: 12 / 54

PECA30 / 30 E : general presentation
12
ARDETEM
DISPLAYED ABBREVIATIONS LIST ON THE DIFFERENT MENUS :
Acc : increase in energy witch provides a pulse
AFF : display programming
AFF. OFF : auto extinguishing of the display, after 5 min.
AnA : 3 analog outputs board (current)
ANA.A : 3 analog outputs (current) + 2 alarm outputs mixed board
ANA.P : 3 analog outputs (current) + 2 pulse outputs mixed board
bAUd : transmission speed (for the serial interface) (baud rate)
brd : optional board
CAL : voltage calibre
CAL Urn : simple voltage calibre (for the network Nr: 4)
CAL UrS : mesh voltage calibre (for the network Nr: 2,3 et 5)
CALC : message displayed during the harmonic calculation
CLr : reset
CLr.E : energies reset
CLr.C : (current, power…) peak value reset,
CLr.H : running time-meter reset
CLr.m : measurement time saving reset
conF : all PECA configuration
dEC.U (dEC.I) : running time-meter set of the UTR or IR presence
dEL : threshold relay commutation delay or pulse time delay
dISP : functions about the display (alarms display, automatic extinguishing,…)
EA.O1 (EA.O2) : active energy out meter 1 : normal ( meter 2 : ex: for EJP )
EA.I1 (EA.I2) : active energy in meter 1 : normal ( meter 2 : ex: for EJP )
ELEC : electrical cosinus (YES) or mathematical (no)
EnEr : energies setting, or capture value from the front key of the PECA
Er.O1 (Er.O2) : reactive energy out meter 1 : normal ( meter 2 : ex: for EJP )
Er.I1 (Er.I2) : reactive energy in meter 1 : normal ( meter 2 : ex: for EJP )
Err : configuration, wiring ...errors visualization
ESCL : Modbus/Jbus slave number for the serial interface
F. num. : measurement logic filtering
FIL.num : total measurement filtering
FIL.PIC : peaks elimination
HAr.U (HAr.C) : Utr voltage harmonic (Ir current)
HI (LO) : high saturation (HIgh) or low saturation (LOW)
hour : time-meter setting
HYS : threshold relay hysteresis
I mA : current output scale in mA
JBUS : Modbus / Jbus optional board
PArA : measurement parameter number (see page 13)
P dS ( P FS ) : Parameter down and Full Scale
PULS : 3 pulse outputs board
P tC ( P tP ) : primaries of the current, voltage external transformer
rAP : external current, voltage transformer ratio
rEAd : PECA configuration (programming) reading
rEC. (gEN.) : network current sense, the load is receiver (generator) of current
rEEL : pattern Modbus transmission in real (floating decimal point) or double integer
rES : measured network (rES Nr..:= network type)
SAVE : captured configuration saving
ScrL : auto scrolling of the pages (scroll)
S tC ( S tP ) : secondaries of the current, voltage external transformer
SECU : threshold relay security or output current saturation in case of alarm
SEnS : current sense (the load is generator or receiver of current)
Sor.1 : Nr 1 output (optional board)
SP 1 ( SP 2 ) : relay threshold 1 (threshold 2 )