ARDESTO FHB-2000TW, Instruction Manual

Page: 23 / 30

EN
19
After using the device, set the operating mode knob (3) to the «off» position
( ) and remove the plug from the outlet.
OVERHEATING PROTECTION FUNCTION
The fan heater is equipped with an automatic function of protection against
overheating.
If the device starts to overheat, the automatic overheating protection system
will work and the fan heater will turn off.
If this happens, immediately set the operation mode switch (3) to the «off»
position ( ) and remove the plug of the power cable from the outlet, let the
fan heater cool down for about 15-25 minutes, and only then can it be turned
on again.
Make sure the back and front grates are clear and nothing is obstructing the
air flow.
Insert the plug into the outlet and turn on the fan heater. If the device does
not turn on, this may indicate the presence of other malfunctions that are not
related to the automatic emergency shutdown function. In this case, contact
an authorized service center.
CAUTION:
To avoid burns, do not touch the heated surfaces of the device
and do not allow hot air to enter exposed areas of the body.
MAINTENANCE AND CLEANING
• Before starting to clean your device, turn off the
device, unplug the power cord for safety and wait for
the device to cool down.
• The outer surface of the device should be cleaned
with a soft, cotton, slightly damp cloth or a soft brush.
• Never use abrasives or solvents to clean the heater.
• Do not clean the product with substances such as
gasoline, thinner solvent, etc. that will corrode or
damage the product.
• Do not clean your device using steam cleaners.