ARDESTO FHB-2000TW, Instruction Manual

Page: 22 / 30

EN
18
DEVICE ASSEMBLY
The device is delivered unassembled. Do not the plug the appliance into the
outlet without fully assembling it.
• Pass the power cord between the halves of the floor support (1).
• Align the tabs on one half of the floor support (1) with holes on the other
half of the support (1) and fix parts with fixing screws.
• Place the assembled support (1) on the lower part of the fan heater
housing (5), make sure that the tabs on housing (5) are coincided with
the holes on the support (1) and after it turn the support (1) until it locks,
fix the support (1) with fixing screws.
• Attach the power cord to the special cord channel on the floor support (1).
Install the fan heater on a flat, dry and stable surface so that the air grates are
not blocked by foreign objects.
Distance between the front grate of the fan heater and flammable materials,
curtainsor furniture, etc. must be at least 1.0 m.
OPERATING THE DEVICE
• Do not use the product if their parts are absent, broken, or damaged.
Contact to the Authorized Service.
• Never cover the air inlet and outlet ducts to avoid damaging the product.
• Do not cover the product with anything. Do not touch the product with
damp and wet hands.
• Your device is equipped with a safety system against overheating.
ATTENTION:
Make sure that no other high-power electrical appliances are
connected to the outlet to which the fan heater is connected.
-
Insert the plug into the outlet.
- Set the operating mode switch (3) to the required position:
– the fan heater is off;
– operation in fan mode;
– low level of heating power (1000 W, for small rooms);
– high level of heating power (2000 W, for large rooms);
– operation in fan mode with housing oscillation;
– low level of heating power with housing oscillation (1000 W, for small
rooms);
– high level of heating power with housing oscillation (2000 W, for large
rooms).