Arctiko BBR100, Operating Instructions Manual, Page: 4 / 36

SAFETY PRECAUTIONS
Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed
to rain water.
Only qualified engineers or service personnel should install the unit. The installation by
unqualified personnel may cause electric shock or fire.
Install the unit on a sturdy floor and take an adequate precaution to prevent the unit from
turning over. If the floor is not strong enough or the installation site is not adequate, this may
result in injury from the unit falling or tipping over.
Never install the unit in a humid place or a place where it is likely to be splashed by water.
Deterioration of the insulation may result which could cause current leakage or electric shock.
Never install the unit in a flammable or volatile location. This may cause explosion or fire.
Never install the unit where acid or corrosive gases are present as current leakage or electric
shock may result due to corrosion.
Always ground (earth) the unit to prevent electric shock. If the power supply outlet is not
grounded, it will be necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.
Connect the unit to a power source as indicated on the rating label attached to the unit. Use
of any other voltage or frequency other than that on the rating label may cause fire or electric
shock.
Never store volatile or flammable substances in this unit if the container cannot be
sealed.These may cause explosion or fire.
Do not insert metal objects such as a pin or a wire into any vent, gap or any outlet on the
unit. This may cause electric shock or injury by accidental contact with moving parts.
WARNING
4