4 — English
UNPACKING
This product requires assembly:
Carefully remove the product and any accessories from
the box. All items listed in the
Includes
section must be
included at the time of purchase.
WARNING:
Items in this
Assembly
section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
ASSEMBLING THE MISTING KIT
See Figures 1 - 4.
To ensure the product functions properly, always flush and
test the system for leaks before use.
To flush system and test for leaks:
Place o-ring into the misting tube coupler.
With the hose faucet turned completely off, attach a
garden hose (not provided) to the misting tube coupler
and hand tighten.
Turn faucet on and allow water to run through the garden
hose and misting tube for 30 seconds to wash away any
debris. Then turn faucet off.
Install drain valve and brass nozzles into the threaded
holes on the misting tube. Install the drain valve into the
threaded hole farthest from the misting tube coupler.
ASSEMBLY
NOTE:
Do not disassemble the drain valve.
Turn faucet on fully and allow water to run through the
garden hose and misting tube to pressurize the unit.
NOTE:
Make sure the faucet is turned on fully and that
there are no kinks or leaks in the hose.
Check each threaded hole on the misting tube for leaks.
If leaks are present, refer to the Troubleshooting section
later in the manual.
NOTE:
It is normal for water to spray from the drain
valve when the hose faucet is initially turned on. The
valve will close once the misting tube has been properly
pressurized.
To prepare system for use:
Turn faucet off and disconnect the misting tube coupler
from the garden hose.
NOTE:
Make sure the o-ring remains in the coupler.
Attach the misting tube coupler to the threaded end of
the T-filter.
Place an o-ring into the open side of the T-filter.
Attach the garden hose to the open side of the T-filter
and tighten securely.
NOTE:
Do not remove the strainer cap and attempt to
attach the misting tube coupler opposite the garden hose.
MOUNTING THE MISTING KIT
See Figures 5 - 7.
WARNING:
Install hanging mounts in an area where no electrical
wires, utility cables, pipes, or other obstructions are
located. Contact your local utility company or a qualified
electrician if you are unsure. Ensure hanging mounts
and misting tube are securely installed to prevent falling
object or slippery surface hazard. Failure to follow these
instructions can result in electrical shock or other serious
personal injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 when using a hammer to
install the hanging mounts and misting tube. Failure to
do so could result in objects being thrown into your eyes
resulting in possible serious injury.
To obtain the best spray area (mist curtain), we recommend
that the misting tube be secured to an overhead support.
Always mount the misting kit in a suitable location away from
electrical devices and switches.
