Arctic Cat Z Series 2006, Operator'S Manual

Page: 74 / 88

MAINTENANCE 73
2. Insert the bulb into the head-
light housing.
3. Check headlight aim (see
Adjusting Headlight Aim in this
sub-section).
Removing Headlight Bulb
(Crossfire/M-Series Models)

N OTE : T h e bu l b p o r t i o n o f
headlight is fragile . H AN DLE
WITH CARE. When replacing the
headlight bulb, the bulb assembly
must first be removed from the
housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing.
To access the headlight bulbs, use
the following procedure.
1. With the hood closed, loosen
the headlight adjustment knobs.
2. Carefully push the headlight
lenses rearward far enough to
remove the torx-head screws
securing the air silencer plenum
to the hood.
3. Open the hood; then remove the
O-rings securing the air silencer
plenum to the hood and remove
the air silencer plenum to
access the bulbs.
4. Remove the bulb from the
headlight housing and discon-
nect the wiring harness from the
bulb.
0740-462
Installing Headlight Bulb
(Crossfire/M-Series Models)
1. Plug the wiring harness into the
headlight bulb.
2. Insert the bulb into the head-
light housing.
3. Press the air silencer plenum
into place on the hood and
secure with the O-rings; then
close the hood.
4. Carefully push the headlight
lenses rearward far enough to
install the torx-head screws.
Tighten the screws securely.
5. Tighten the headlight adjust-
ment knobs.
6. Check headlight aim (see
Adjusting Headlight Aim in this
sub-section).
! WARNING
Do not operate the snowmobile
u n l e s s h e a d l i g h t b e a m i s
adjusted properly. An incor-
rectly adjusted beam will not
provide the operator the opti-
mum amount of light.
! CAUTION
Do not touch the glass portion
of the bulb. If the glass portion
is touched, it must be cleaned
with a dry cloth before install-
ing.