Arctic Cat Z Series 2006, Operator'S Manual

Page: 73 / 88

72 MAINTENANCE
Removing Headlight Bulb
(3-Bulb Style)

NOTE: The bulb portion of the
headlight is fragile . H AN DLE
WITH CARE. When replacing the
headlight bulb, the bulb assembly
must first be removed from the
housing.
1. Pull the wiring harness retain-
ing clip away from the head-
light bulb base and disconnect
the wiring harness from the
bulb.
0733-178
2. Rotate the headlight bulb base
counterclockwise and remove
the bulb from the headlight
housing.
Installing Headlight Bulb
(3-Bulb Style)
1. While holding the bulb by its
base, insert the bulb into the
headlight housing and rotate it
clockwise until it locks into the
housing.
2. Plug the wiring harness into the
headlight bulb base making
sure the retaining clip locks
onto the base.
3. Check headlight aim (see
Adjusting Headlight Aim in this
sub-section).
Removing Headlight Bulb
(4-Bulb Style)

NOTE: The bulb portion of the
hea dl ight is fragile . HA ND LE
WITH CARE. When replacing the
headlight bulb, the bulb assembly
must first be removed from the
housing.
1. Remove the bulb from the
headlight housing and discon-
nect the wiring harness from the
bulb.
0740-462
Installing Headlight Bulb
(4-Bulb Style)
1. Plug the wiring harness into the
headlight bulb.
! CAUTION
Do not touch the glass portion
of the bulb. If the glass portion
is touched, it must be cleaned
with a dry cloth before install-
ing.
! WARNING
Do not operate the snowmobile
u n l e s s h e a d l i g h t b e a m i s
adjusted properly. An incor-
rectly adjusted beam will not
provide the operator the opti-
mum amount of light.
! CAUTION
Do not touch the glass portion
of the bulb. If the glass portion
is touched, it must be cleaned
with a dry cloth before install-
ing.