Arctic Cat Bearcat 570 XT, Operator'S Manual

Page: 12 / 72

8
FZ003C
A. Oil Pressure/Low Oil
B. Coolant Temperature
C. Low Fuel
D. Fuel Level
E. Service
F. High Beam
G. Charging System (Bearcat Z1
XT/TZ1 Models)
RPM/MPH (kph)
By pushing the left button once, the RPM
and MPH will be displayed (one on the
readout screen and one with the needle).
By pushing the button once again, the
functions will be reversed.
By pushing the left button (with speed
being displayed) for more than two sec-
onds, the display will change between
standard mph or metric kph. Release the
button when desired display appears.
With RPM displayed on the readout
screen by pushing and holding the left
button, maximum RPM will be displayed
on the readout screen. The maximum
RPM readout will reset when the right
button is pushed (while maximum RPM
is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-
Meter/Clock

NOTE: The clock is available on
electric start models only.
By pushing the right button, the readout
screen will display odometer, trip-meter
(1), trip-meter (2), hour-meter, and clock.
To reset the trip meter with the trip meter
displayed, push and hold the right button
until the display is cleared. The hour-
meter readout will not reset.
Clock (Electric Start)
With the clock selected on the readout
screen by pushing and holding the right
button for two seconds, the option of
selecting the 12-hour or 24-hour clock is
available. Push the left button for 12-hour
display; push the right button for 24-hour
display. At this point, the hours and min-
utes will begin to flash. Push the left but-
ton to change the hour display; push the
right button to change the minute display
(either tap the buttons for individual num-
ber display or push and hold the buttons
for rapid number display).

NOTE: During clock setting if nei-
ther button (left, right) is pushed
within a 5-second time period, the
clock-setting mode will be exited
with changes saved.
Service Icon
On electric start models, the icon should
illuminate each time the key is turned to
RUN or START, and it should go out when
the engine starts. If the icon stays illumi-
nated (on electric start models) or it illumi-
nates while the engine is running, the
system is receiving input that is outside of
its established parameters. If the icon illu-
minates indicating an error, take the snow-
mobile to an authorized Arctic Cat
Snowmobile dealer for service. If not
under warranty, this service is at the dis-
cretion and expense of the snowmobile
owner.
Coolant Temperature
Warning Icon (Bearcat Z1
XT/TZ1 Models)

NOTE: When cold-starting the
engine, the coolant temperature
warning icon will illuminate, the read-
out screen will display TEMP, and
engine RPM limit will be below drive
system engagement speed.
When the engine reaches proper operat-
ing temperature, the coolant temperature
warning icon and TEMP display will
cease to flash.