49
NOTE: On the LTD, place the third
seat into position on the mount making
sure the two pin holes are properly
aligned with the mounting location on
the mount; then install the two pins
making sure they are properly seated.
Removing and Installing
Taillight/Brakelight Bulb
(Bearcat 2000 LT/Lynx
2000 LT)
1. Remove the torx-head cap screws
securing the taillight access panel.
742-467A
2. Disconnect the harness connector
and remove housing.
3. Push in on the socket and rotate it
counterclockwise to remove it from
the housing.
4. Remove the old bulb by pulling it
straight out of the socket.
5. Install the new bulb in the socket by
pushing it straight in.
6. Push the socket into the housing and
rotate it clockwise to lock into place.
7. Connect the harness connector.
8. Secure the access panel with the
torx-head cap screws.
Removing Headlight Bulb
NOTE: The bulb portion of headlight
is fragile. HANDLE WITH CARE. When
replacing the headlight bulb, the bulb
assembly must first be removed from
the housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a dry
cloth before installing.
To access the headlight bulbs, use the fol-
lowing procedure:
1. Remove the two torx-head screws
located to the outside of the head-
light adjustment knobs; then remove
the single torx-head screw from
beneath
the
console
(located
between the headlights).
743-439A
2. Remove the cap screw and lock nut
securing the front of the headlight
assembly to the air-intake silencer.
3. Lift the front of the console enough
to allow the headlight housing to be
removed; then remove the housing.
4. Remove the bulb from the headlight
housing and disconnect the wiring
harness from the bulb.
741-329A
! WARNING
Make sure the rear seat (and on the LTD,
the third seat) is securely locked in place
with the pins before carrying a passen-
ger or personal injury may result.
