Arctic Cat ATV 2010, Operator'S Manual

Page: 43 / 72

41
GENERAL
INF
O
RMA
T
IO
N
SEAT LOCK
1. To remove the seat, push the
seat lock lever rearward
(located at the rear of the
ATV under the seat). Raise
the rear end of the seat and
slide it rearward.
2. To lock the seat into position, slide the front of the seat into
the seat retainers and push down firmly on back of seat. The
seat should automatically lock into position.
SAFETY FLAG/BRACKET
A bracket is provided for mounting a flag at the rear of the ATV.
The flag should be displayed to make the ATV more visible.
TRANSPORTING ATV
When transporting the ATV, Arctic Cat recommends that the ATV
be in its normal operating position (on all four wheels) and the
following procedure be used.
1. Engage the brake lever lock.
2. Turn the fuel valve OFF.
3. Secure the ATV with load rated hold-down straps.

NOTE: Suitable hold-down straps are available from your
Arctic Cat ATV dealer. Ordinary rope is not recommended
because it can stretch under load.
GASOLINE-OIL-LUBRICANT
Recommended Gasoline
The recommended gasoline to use in this ATV is 87 minimum
octane regular unleaded. In many areas, oxygenates (either etha-
nol or MTBE) are added to the gasoline. Oxygenated gasolines
containing up to 10% ethanol, 5% methane, or MTBE are accept-
able gasolines.
When using ethanol blended gasoline, it is not necessary to add a
gasoline antifreeze since ethanol will prevent the accumulation of
moisture in the fuel system.
CAUTION
Do not overfill the engine with oil. Always make sure the oil
level is between the lower and upper levels on the stick.
! WARNING
Make sure the seat is secure before mounting the ATV.
Severe personal injury may result if the seat is not properly
secured.
KM013A
CAUTION
When using hold-down straps, care must be taken not to
damage the ATV.
CAUTION
When transporting the ATV, make sure the brake lever lock
is engaged and the ATV is properly secured.
CAUTION
Do not use white gas. Only Arctic Cat approved gasoline
additives should be used.