78
4. With the ignition switch in the ON position, select
the DC volts position on the tester; then apply either
brake. The meter must read battery voltage. If battery
voltage is observed and no audible “click” was heard
in step 1 or 2, remove the tester leads and replace the
start-in-gear relay.
5. Shift the gear selector out of neutral and connect a
jumper wire between the yellow/green wire (2) and
the green wire (4).
KM460A
6. Momentarily depress the starter button. The starter
should engage. If the starter engages, replace the
start-in-gear relay. If the starter does not engage,
troubleshoot the battery connections, starter relay, or
starter connections.
Fuse Block
The fuses are located in a fuse block under the seat.
If there is any type of electrical system failure, always
check the fuses first.
NOTE: To remove a fuse, compress the locking tabs
on either side of the fuse case and lift out.
KM102
NOTE: The ignition switch must be in the LIGHTS
position.
1. Remove all fuses from the fuse block.
2. Set the meter selector to the DC Voltage position.
3. Connect the black tester lead to ground.
4. Using the red tester lead, contact each end of the 30
amp fuse holder connector terminals individually.
5. The meter must show battery voltage from one side
of the connector terminal ends.
6. Install the 30 amp fuse; then using the red tester lead,
check the remaining two fuse holder connectors as in
step 4.
NOTE: Battery voltage will be indicated from only
one side of the fuse holder connector terminal; the
other side will show no voltage.
NOTE: If the meter shows no battery voltage, trouble-
shoot the battery, fuse block, or the main wiring harness.
Fuses
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to one spade end of the
fuse; then connect the black tester lead to the other
spade end.
AR610D
3. The meter must show less than 1 ohm resistance. If
the meter reads open, replace the fuse.
NOTE: Make sure the fuses are returned to their
proper position according to amperage. Refer to the
fuse block cover for fuse placement.
LCD Gauge Assembly
REMOVING
To remove the LCD gauge assembly, see Steer-
ing/Body/Controls.
TESTING
NOTE: If any functions (segments or displays) are
not normal or do not display as indicated, the LCD
gauge must be replaced.
1. Remove the instrument pod; then disconnect the
speedometer cable. Leave the gauge connected to the
wiring harness.
NOTE: To perform the following tests, two Maxi-
Clips and one jumper wire will be required.
2. Connect the black MaxiClip to the green/black wire.
Summary of Contents for Altera 300
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com ...
Page 99: ...98 NOTES ...
Page 100: ...99 NOTES ...
Page 101: ...100 NOTES ...