Arctic Cat Altera 300, Service Manual

Page: 44 / 102

43
7. Unwind the rope from the reel and remove the rope.
Cleaning and Inspecting
1. Clean all components.
2. Inspect the springs and ratchet for wear or damage.
3. Inspect the reel and case for cracks or damage.
4. Inspect the shaft for wear, cracks, or damage.
5. Inspect the rope for breaks or fraying.
6. Inspect the spiral spring for cracks, crystallization, or
abnormal bends.
7. Inspect the handle for damage, cracks, or deteriora-
tion.
Assembling/Installing
1. If removed, insert the spiral spring into the case with
the outer end of the spring around the mounting lug
in the case; then wind it in a counterclockwise direc-
tion until the complete spring is installed.

NOTE: The spiral spring must seat evenly in the
recoil case.
KM402
2. Insert the rope through the hole in the reel and tie a
knot in the end; then wrap the rope clockwise around
the reel leaving approximately 50 cm (20 in.) of rope
free of the reel.
3. Apply low-temperature grease to the spring and hub.
4. Thread the end of the rope through the guide hole of
the case; then thread the rope through the handle and
washer and secure it with a double knot. Install the
protective cover into the handle.
KM400
KM405
5. Align the inner hook of the spiral spring with the
notch in the reel spacer.
KM402A
6. Install the ratchets making sure the ends are properly
oriented on the reel.
KM397A
7. Install the spacer, spring, and the ratchet guide mak-
ing sure the ratchet pins engage the guide.
KM401