Arctic Cat Altera 300, Service Manual

Page: 22 / 102

21
6. Using a flat blade screwdriver, release the connector
locking tabs; then disconnect the tail light/brakelight
connectors.
XA084A
7. Remove the four cap screws securing each tail
light/brakelight assembly to the rear body panel
assembly. Remove the tail light/brakelight assem-
blies.
XA085A
8. Remove the rear body panel assembly.
CLEANING AND INSPECTING
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
3. Inspect threaded areas of all mounting studs for strip-
ping.
4. Inspect for missing decals.
INSTALLING
1. Place the rear body panel into position on the frame
while guiding the SIG relay, starter relay, and PDM
through the front of the body panel. Secure the two
halves of the CVT outlet tubes together with the
clamp.
2. With the four steel inserts installed into each rubber
grommet, place the rear rack into position and secure
with the four cap screws.
3. Place the rear over-mold atop the rear rack and
secure it using the self-tapping screws.
XA080A
4. Install the six cap screws securing the front body
panel to the frame, gas tank, and rear body panel;
then install and secure the gas tank cover and steer-
ing post covers using the plastic reinstallable rivets.
XA077A
5. Place the PDM, SIG relay, and starter relay into their
respective positions within the battery tray. Ensure
the PDM locks into place. Connect the starter relay
primary connector (B) and green ground wire con-
nector (A).
XA076A
6. Place each tail light/brakelight assembly into place
and secure with the cap screws. Connect each wire
connector to the main harness; then secure to the
frame.