3-119
3
MD1327
9. Install the input driveshaft.
MD1326
CC870
10. Install the washer, spacer, sleeve, reverse idler
gear, and washer.
MD1357
11. Install the secondary and primary driveshaft
assemblies. Account for the bearing alignment
C-ring on the bearing boss next to the pinion
gear.
NOTE: Align the bearing alignment pin on the
secondary output shaft.
MD1316
Joining Crankcase
Halves
1. Verify that the two alignment pins are in place
and that both case halves are clean and grease
free. Apply Three Bond Sealant (p/n 0636-070)
to the mating surfaces. Place the right-side half
onto the left-side half.
MD1336
2. Using a plastic mallet, lightly tap the case halves
together until cap screws can be installed.
3. From the right side, install the crankcase cap
screws noting the location of the different-sized
cap screws; then tighten only until snug.
NOTE: Rotate the shafts back and forth to
ensure no binding or sticking occurs while tighten-
ing the cap screws.
Back to TOC
Back to Section TOC
Next
Back
Summary of Contents for 400 TBX
Page 1: ......