8-4
CM005
3. Tighten the lock nuts to 96 in.-lb; then install the
close-out panel and secure with torx-head cap
screws.
4. Install the two lower cap screws (threads coated
with blue Loctite #243) on each side of the steering
support. Tighten to 20 ft-lb.
SC085A
5. Place the steering tie rod into position on the steer-
ing post. Secure with the cap screw (threads coated
with green Loctite #609) and new lock nut. Tighten
the lock nut to 30 ft-lb.
FC205
6. Secure the console to the gas tank with the torx-
head cap screws and four lock nuts. Tighten
securely; then install the ignition switch.
7. On the standard model, secure the adjuster block to
the steering post with four cap screws and lock
nuts. Tighten to 120 in.-lb.
8. On the Sno Pro and HCR models, install the adjust-
ing block cover and position the handlebar into the
mounting block; then install the handlebar clamp
and tighten the four cap screws to 20 ft-lb.
0743-467
NOTE: Steps 9-13 are for the CFR.
9. Install the handlebar riser block assembly to the
steering post; then secure the assembly with the
retainers (A) and set screws.
0744-927
10. With the lock rod (B) and springs (C) in place,
thread the cam lever into the lock rod far enough to
hold the handlebar in position.
11. Depress the lock pin, lift up on the cam lever, and
swing the handlebar up and rotate to the desired
position; then press down on the cam lever until the
lock pin is properly positioned. Check steering for
maximum right/left turning capabilities.
0741-427
Next
Back
Section
Table of Contents
Manual
Table of Contents
Summary of Contents for 120 Sno Pro 2010
