Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
32
4.1. Description of Manual Mode Window
The window display in manual mode is the same as it in automatic mode except that the
multiplying factor is manually adjustable, which affects manual operation, return speed to
reference point, move speed, etc. There are some special operations in manual mode as follows:
4.1.1 [
↑
], [
↓
], [
←
], [
→
] directional control keys and [G] Continue Key
Generally, if any of the four direction keys is pressed and held, appropriate axial movement
will carry on until the key is released. However, if [G] Continue key is pressed and highlighted
before any direction key is pressed, the cutting torch will keep moving even if the key is released.
The movement will not stop until the direction key is pressed again. If two axial movements are
required, let one axial movement start first and then press the direction key for the other axial
movement. Two axial movement will go on simultaneously. In this case, the axial movement of
cutting torch will stop if the corresponding direction key is pressed while the other axial
movement will go on until the corresponding direction key is pressed too. [PAUSE] key will stop
the movement as well.
4.1.2
【
F1
】
AUTO
The system is switched to automatic mode.
4.1.3
【
F2
】
STEP
If STEP function (highlighted) is selected, the system will prompt to input STEP INCREMENT:
0050.000 (previous input value by default). In STEP mode, if direction key is pressed once, the
cutting torch will move an increment at the speed of the current maximum speed limit multiplied
by multiplying factor.
4.1.4
【
F4
】
CORR
When the steel plate is placed on the material table, the steel plate may be inclined or the
steel plate needs to be rotated by an angle due to other reasons, and then this function can be
selected during processing.
Operation method:
First move the torch to a certain position on the side of the steel plate,
Press number 1 START;
