Arcam SOLO NEO, User Manual

Page: 14 / 88

E14
Inserting batteries into the
remote control
remote
control
SLEEP
CR50
CR50 Remote control buttons
2
(Power)
– Switches Solo Neo between stand-by and on.
Track/preset selection (0–9)
– Press the number of the CD track or radio preset that you want to hear. To
select a track/preset greater than 9, press and hold the first digit of the track (e.g.
1
) until the number is
shown in the bottom left corner of the display (‘1–’), then press the second digit.
INFO
– Changes the information shown on the front panel display.
MODe
– Some sources allow changes to the listening mode.
CD/USB/NET Media – Press the
MODe
button to cycle through the repeat/shuffle modes for CD playback.
DAB/FM – Press
MODe
to switch between ‘tune’ and ‘preset’ mode. When in tune mode, pressing B or
C changes the tuned frequency (FM) or the selected station (DAB); in preset mode, the preset station is
changed.
NET Radio – Press the
MODe
button to add or remove favourite stations.
DISP
– Cycles the brightness of the front-panel display. There are several different brightness levels to chose
from, including switching the display off.
SLeeP
– Activates the sleep timer function. The time until entering standby can be set in 5-minute steps.
MeNu
– Pressing the
MeNu
button allows entry into the configuration menu of Solo Neo. This is described fully
on pages 15—19. Press the
MeNu
button for a second time to leave the menu.
Source selection
– Press the appropriate button to select the audio source you would like to hear. The
eXT
button cycles through the external inputs
AV
,
TV
,
GAMe
and
FRONT
.
Cursor keys and OK
– The cursor is used to choose items to play from USB and NET sources. These keys also
find use in navigating the configuration menus of Solo Neo, described on pages 15—19.
Mute
– Press once to mute the speaker and pre-amp outputs of Solo Neo. Press for a second time (or change the
volume) to unmute the unit.
Volume – Use the
-
/
+
buttons to adjust the volume of the music.
CD/uSB/NeT Media playback commands
4 (Play) – press this button to start the playback.
< (Stop) – press to stop playback.
;
(Pause) – press to pause playback . Press again (or press play) to re-start playback.
/ (Skip/Scan backwards) – press and release this button to skip backwards to the beginning of the current/
previous track. Press and hold the button to scan backwards.
0 (Skip/Scan forwards) – press and release this button of skip forwards to the beginning of the next track.
Press and hold the button to scan forwards.
1 (Open/Close) – press to open the CD tray; press again to close it.
1. Open the battery compartment by pressing the
button on the back of the remote control.
2. Insert two ‘AAA’ batteries into the battery
compartment, following the polarity indications
given inside the compartment itself.
3. Push the battery cover back into position.
using the remote control
Please keep in mind the following when using the
remote control:
<
Ensure that there are no obstacles between
the remote control and the remote sensor
on Solo Neo. The remote has a range of
about seven meters. (If the remote sensor
is obscured, the remote control input jack
on the rear panel is available. Please contact
your dealer for further information.)
<
Remote operation may become unreliable if
strong sunlight or fluorescent light is shining
on the remote sensor of Solo Neo.
<
Replace the batteries when you notice a
reduction in the operating range of the
remote control.