47. Pass the looms up under the front of the
vehicle on each side and in between the
wheel arch liners and the body until they
are visible through the holes made by the
removal of the indicator lamps.
Note: Ensure the convoluted tube is covering
the section of the loom that passes between
the wheel arch liner and the body.
48. Using the scotch locks provide connect the
looms to the vehicles indicator wiring.
Connect black with black and red with
green.
49. Cover the joins with electrical tape.
50. Test the wiring by switching the vehicles
indicators on and checking to see if the
new bar lamps work correctly.
51. Replace the indicators onto the vehicle.
52. Tidy the wiring using cable ties.
53. If a winch is not fitted, fit the number plate
to the lower 2 holes above the winch cavity
using M6 hex bolts, M6 washers and M6
flange nuts.
54. If a winch is fitted, fir the number plate to
the bracket installed in the winch
installation using the same hardware as
noted above.
55. Driving lights can now be fitted to the
vehicle.
