29. Drill through the chassis rails with the
10mm drill bit using the upper holes in the
mount bracket as a guide.
30. Repeat both sides.
31. Use paint or anti rust on the bare metal of
newly drilled hole.
Note: Only drill through one side of each rail.
32. Place an M10 SEMS bolt assembly through
each of the hols and secure using M10
flange nuts.
33. Tighten to above specified torque setting.
Note: If fitting a winch, it should be done now
using fitting kit 3532070 and fitting
instructions 3787082
34. Replace the grille using the screws
removed in step 1.
35. Place the bar back into position and re-
secure using the M12 fasteners and shims
if required.
36. Locate bar as per step 16.
37. Tighten all fasteners to above specified
torque setting.
38. Using the holes in the mount brackets as a
guide, drill pinning holes through the bar
mounts.
39. Place an M10 SEMS bolt assembly through
each of the holes and secure using M10
flange nuts.
40. Tighten to above specified torque setting.
