18
English
Regent-X
To reinstall, make the same M-shaped fold at the front and V-shaped fold at
the rear of the same comfort lining. Paying attention to its direction, put it into
the helmet and unfold it.
Align the bottom of the comfort lining with the bottom the EPS lining of the
helmet, and center
2
vertical stitches on the comfort lining with the V-shaped
mark of the black lining on the EPS.
Once the front part of the comfort lining sits in the helmet properly, fully secure
both front hook-and-loop fasteners on both sides.
Insert both side tabs of the comfort lining between the shell and EPS lining until
both tabs wrap smooth around the EPS liner and are tucked fully into place.
Lifting the neck roll pad slightly, center and secure the hook-and-loop fastener
at the rear and adjust the comfort lining to smoothly sit in the helmet.
WARNING :
Do not put your gloves or anything that use hook-and-loop
fasteners. Hooks of the fasteners may grab onto the comfort lining resulting
in damage to the liner. They may even pull the comfort lining out unexpectedly
from the helmet as you pull such articles from the helmet.
